Help with mfj 1270B
 

Hi all.

I just picked up a couple of MFJ 1270B's. I want to be able to simple
send anything recieved on the serial port via radio to the other one
and then have it send it to my PC. Thats it.

So I fired them up with a terminal software connected to each one. I
then typed TRANS as I thought this was what I needed. Ok I type in
some charecters on on. It waits a few seconds after I type and then
the unit transmits the data.

The DCD light comes on over at the second unit but nothing shows up on
the terminal screen.

However if I leave it in the default mode which I think is called
CONVERSATION MODE I get the line

cmd:NOCALLCQ UI R:THIIS IS WHAT I TYPED


so I know it is transmitting it.

What am I missing. Are these units not capable of doing this? I need
the recieveing unit to be able to transmitt back so do I have to
switch modes etc?

MAybe these units are too old to do what I want..
Any help appreciated...