[S&DARC] Simple 2m Antennas
 

Southport and District Amateure Radio Club

///////////////////////////////////////////
Simple 2m Antennas

Posted: 17 Sep 2020 10:38 AM PDT
https://southportadarc.org.uk/simple-2m-antennas/













Simple 2m Antennas, Base and Mobile for Beginners

The club has recently had an influx of new member, some of which are new to
the world of amateur radio. Some have bought the cheap Baofeng handheld
transceiver to listen to activity on 2m and 70cm. It has been reported that
reception on the rubber duck antenna that comes with the transceiver is not
that good.

Therefore, I have put together some ideas for simple antennas that can be
easily put together.

This is not meant to undermine the technical prowess of some members but is
more directed to newcomers and show how some simple solutions can be
developed.

The 2m FM band is from 145.200 to 145.615Mhz, channelised with 12.5Khz
separation i.e. 145.200, 145.2125, 145.225 etc. With the calling channel at
145.500 Mhz. Taking the centre of the band to be approximately 145.400Mhz a
half wave dipole would be 1.03m in length with two quarter wave elements of
515mm.

The first example is a dipole made from coax stuck to a window. Trim back
520mm of the coax outer, then making a hole in the braiding pull the inner
through. Inner goes up braid goes down (not that it matters much) remaining
coax at right angles to the dipole. Trim both ends of dipole for best SWR
at 145.4Mhz. If aesthetics are not a problem the antenna could be put on
two pieces of wood in T formation and stuck out a window. This will also
work in the loft. All depends where your shack is and could you hide it
behind the curtains of a window. Remember the higher the antenna the
better, especially if you are surrounded be higher houses than your own.
This antenna can be made for 70cms by adjusting the dimensions. The half
wave dipole is the basis of the most popular and easiest resonant antenna
to build albeit single frequency.




2 If a more permanent solution is required, then using commercially
available PL259 female dipole “T” to 3/8 screw fittings. Adaptors then hold
steel rods and screw into the 3/8 screw sockets. The steel rods can come in
various length lengths dependant on the supplier and can be cut to the
appropriate length for best SWR. This dipole then can be attached to the
wall with a TV type bracket



This setup is on a broom handle and for 2m. I stick it out of the upstairs
window and work Barrow.

For mobile use a similar setup can be used if you have a roof rack mounting
or gutter mounting with a 3/8 fitting, then a steel rod with the 3/8
adaptor can be used on a car or van.




The other option for mobile working is a mini mag mount I had this for when
I first got a handheld and took it in the car. It covered 2m and 70cm.




But I now use a colinear with a PL259.



I hope this gives you food for thought and it is only quick, cheap, and
cheerful solutions.

Remember initially cut long you can always remove but it is difficult to
add on, and trim in small amounts until you get a feel for what your doing.

That’s why the coax solution is always a good starter for 10.

Regards and 73 Brian M0SSN









The post Simple 2m Antennas appeared first on Southport and District
Amateure Radio Club.