About Us

Anthony Fremont

wrote:
On Mar 13, 12:02 pm, "Anthony Fremont" wrote:

I believe this is direct conversion and that the crystal should
exactly match the desired station (3581kHz) I want to recieve,
that's right isn't it? Maybe this is close enough? I have to wait
til tonight to see if I can actually hear anything.

Depends on what sort of signal you are trying to receive.

To receive a single our double sideband signal (or, in a very touchy
way, an AM one), you want your direct conversion receiver's local
oscillator exactly on the transmitter frequency.

But to receive a CW signal, you want your local oscillator 700 Hz or
so above or below the transmit frequency. That will cause you to hear
a 700 Hz audio tone for the CW.

Unless I'm mistaken, 3.581 MHz is in the CW portion of the 80 meter
band.

It is, I mistakenly thought they did the 80 meter voice announcement down
there. The voice bulletin is actually on 3990kHz.

Since I have most of what I need (tuning caps, vernier and toroids/wire) I
started looking around at different VFO circuits. I'm trying to find
something that will span from 3500 to 4000kHz and still be fairly simple. I
could then inject this into pin 6 of the 602 and be done with it. :-)

If you can get to 1 KHz below the transmitter, you should be able to
copy CW as 1KHz audio. If you can only get to 1.5 KHz below, you'll
get 1.5 KHz audio... not ideal listening, but probably workable.

Right. I was hoping to be able to "get on the other side" of the signal to
have a second chance at avoiding possible QRM.

Thread Tools	Search this Thread
Show Printable Version	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
High Frequency Propagation Models	[email protected]	Shortwave	0	January 19th 06 02:40 PM
Get High	Burr	Shortwave	0	May 15th 05 05:37 AM
Production of High frequency Crystals.	Pankaj Trivedi	Homebrew	2	December 15th 04 01:40 AM
Channel-based AM tube tuner (was Designs for a single frequency high performance AM-MW receiver?)	Jon Noring	Shortwave	103	June 30th 04 07:13 PM
Wanted- Used Motorola UHF JT1000 High Split (470-520mhz), & a used Syntor X-9000 UHF High-Split	Joe11426	Swap	0	November 5th 03 05:12 AM

Menu

About Us