clarke wrote:
Hi, check this link and see what you need to do,
one or two pass trans. will not do the job for you,
easier to use 6-10 pass trans to share the load.

http://www.mitedu.freeserve.co.uk/Ci...er/1230psu.htm

Is your transformer able to supply necessary power to this supply ?

regards,
clarke


Deos wrote:


Hi everyone I have made a power supply for my rigs

The schematic is the typical regulator with power transistor wrapped around
it for the extra juice.

I need 40 amps continues ..

I tried 4 mj2955 which are rather nice for foot warming in the winter .

I also tried nte-180 which are very good. is there anything better at a
logical price

I would like to keep the number of transistors down to 1 or 2.

Can someone advise my on what to use for power?

--
http://www.qsl.net/sv1hao


If you want to keep it to a couple transistors they would be expensive.
You are better off using either more NTE-180 or more mj2955, but I would
cut the voltage down to around 18 volts instead of 24 volts as this
higher voltage leads to more heat for the transistors. Rob