In message , Frank Dinger
writes
I have a number of transformers and would like to experiement using then
at
a higher frequency....let say 500 hz and / or higher.....

Would they still work?...I am assuming so...

Would they run cooler?....

Could anyone foresee any negative effects?....
=========================
Running transformers on a higher freq is fine provided the core can manage
the higher freq.

During the valve era ,aeronautical radio equipment ran on 400 Hz resulting
in smaller and hence lower weight transformers.

However running power supply transformers at an AC frequency lower than the
one they are designed for might cause the laminated core to overheat.

In practice : 50 Hz transformers meant for use in Europe and elsewhere can
be readily used in the US and Canada.
However transformers designed for 60 Hz having 'marginal cores' could
overheat when used on a 50 Hz supply.
So equipment with 'wallwarts' purchased in the US ,(apart from being
suitable for 117 V only ) I never use on a 50 Hz supply system.

Nowadays with much equipment having a switch mode power supply , the
frequency / voltage problem no longer exists.

Frank GM0CSZ / KN6WH



Yes, you can sometimes have serious trouble on 50Hz when the equipment
was designed in a 60Hz area. The problem is simply not enough inductance
in the transformer for the lower frequency (even though the difference
is small).

I recall two examples from my work (in the cable TV industry):
1. Hundreds of 50 to 600MHz outdoor repeater amplifiers, line powered
(via the coax) at 60VAC. Took far too much current, and all the
transformers had to be replaced.
2. Piece of rack equipment. 115V input, multiple output windings. We
simply provided a 240-115V step down when we installed it. No problems.
One day, new unit, fuse pops after a few seconds. Mains transformer same
part number, but different supplier, also slightly fewer laminations.
Current went up from 0.2A to 3A. Not an easy fix.

There can also be a problem with switch mode power supplies, but the
problem is not the frequency. It is the higher inrush current when you
switch on. Again, cable TV equipment, had 0.25A mains fuse. Regularly
popped fuse on switch-on. Took a slow-blow 1A to stop it, although the
steady-state current was only 80mA.

I'm not pro-American, but I often think that the world might have been a
simpler place if we had all used 115VAC, 60Hz, 525-line TV etc....

Ian.

--