Home |
Search |
Today's Posts |
|
#1
|
|||
|
|||
Connectin a TO-92 hall effect sensor to wires
What is the best way to attach a hall effect sensor in a TO-92 package
to 22 gauge solid wire? I've tried just laying the wire next to the to-92 lead and soldering them together, but I don't get much of a mechanical connection doing that. Is there some type of sleeve I should be using prior to the soldering? Also, any suggestion on encapulating the device once the electrical connections are made? |
#2
|
|||
|
|||
tim wrote: What is the best way to attach a hall effect sensor in a TO-92 package to 22 gauge solid wire? I've tried just laying the wire next to the to-92 lead and soldering them together, but I don't get much of a mechanical connection doing that. Is there some type of sleeve I should be using prior to the soldering? Also, any suggestion on encapulating the device once the electrical connections are made? I'd mount it on a small PCB (I make my own). It could just be encapsulated in epoxy resin. Leon -- Leon Heller, G1HSM Email: My low-cost Philips LPC210x ARM development system: http://www.geocities.com/leon_heller/lpc2104.html |
#3
|
|||
|
|||
tim wrote: What is the best way to attach a hall effect sensor in a TO-92 package to 22 gauge solid wire? I've tried just laying the wire next to the to-92 lead and soldering them together, but I don't get much of a mechanical connection doing that. Is there some type of sleeve I should be using prior to the soldering? Also, any suggestion on encapulating the device once the electrical connections are made? I'd mount it on a small PCB (I make my own). It could just be encapsulated in epoxy resin. Leon -- Leon Heller, G1HSM Email: My low-cost Philips LPC210x ARM development system: http://www.geocities.com/leon_heller/lpc2104.html |
#4
|
|||
|
|||
|
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|