LinkBack Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
  #6   Report Post  
Old March 3rd 05, 01:23 PM
Richard Hosking
 
Posts: n/a
Default

Did the audio go through a LPF for the phasing unit?
Remember that a square wave is made up of the sum of many harmonics -
most of these will have been removed and the amplituyde of the
fundamental may not be that large.

Richard


andreas magun wrote:
Hi,

I have assembled a T2 phasing exciter (KK7B) and looked
at its output spectrum with a spectrum analyzer.

When pumping the exciter with quadrature sine wave signals it
works as expected (output power roughly 3 mW, sideband supression
better than 40 db).

However, when pumping with quadrature squarewave
signals of approximately the same power, the output power
drops by a factor of at least 20 db! I would have expected
much more power, similar to that obtained with sine wave pumping.

The quadrature phase signal was generated with a 74F74, the
quadrature signals being attenuated to give a power of approx. 10 dbm
and output impedances of approx. 50 Ohms.

There must be an explanation.

Thanks
Andreas


 
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
FA: GE MASTR II, VHF, PLL EXCITER board GW Swap 0 October 10th 04 06:19 PM
homebrewing on perfboard, how to connect components James W Homebrew 47 February 11th 04 12:42 AM
Scanner Bearcat 250 Help! Nick Scanner 6 September 27th 03 08:59 PM
WTB VOX board GT550 Dave Edwards Equipment 0 July 12th 03 12:43 AM


All times are GMT +1. The time now is 10:50 PM.

Powered by vBulletin® Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004-2025 RadioBanter.
The comments are property of their posters.
 

About Us

"It's about Radio"

 

Copyright © 2017