About Us

June 24th 06, 07:00 PM posted to rec.audio.tubes,rec.radio.amateur.homebrew

In article ,
says...

On Fri, 23 Jun 2006 17:43:40 -0500, (Gudmundur)
wrote:

In article ,
says...

Gudmundur wrote:

Hey my man, what you may have is a classic case of the grid coupling
capacitor breaking down and killing your bias on the grid. It is
not uncommon for the grid to go positive and cause the tube to melt!!

You haven't read the thread fully have you ?

Graham

Well let's see, the original poster said the voltage across the grid
resistor seemed wrong, (leaky cap is possible there) and he said the
current kept going up and up (leaky cap getting worse with ambient
heat from the tube) and a blue glow which I find to be typical with
many tubes of the 807 style when there is excess plate current such
as may be caused by A LEAKY CAP between the control grid of the 807
and the previous stage plate voltage. Gassey tube causing runaway,
yes in circuits with high ohmic value grid resistors which is why the
d.c. impedance of power output stage grid circuits is usually low
and and includes an rf choke to keep the rf impedance high. Then, even
with a gassey final power output tube the output stage will be less
likely to run away even with a crappy tube. The original poster
added that after his experience with the runaway tube it seemed to
glow even bluer, no doubt!!!! Guess he liberated even more gass from
the internal overheated elements such as may be caused by 'a leaky
grid coupling cap' in a high resistance grid circuit connected
to a power output tube that is a bit gassey and may be experiencing
such positive grid voltage excursions during peaks causing the
grid to heat and become an even better emitter of electrons causing
a chicken and egg roundabout until the death of a slightly gassey
tube which will find it's final resting place in a landfill beside
some misfit unwanted LEAKY CAPS that I have personally cut out of
some older Seeburg jukeboxes with a problem exactly like the one
the original poster was describing.

I suspect that when he says "read the thread fully" he may be
referring to where the OP said "The coupling capacitors are indeed
good and moving the tube around it
follows the tube."

Yes, that post was missing on my newsreader, as were several of
the replies. WinVN newsreader gets kind of weird like that sometimes.
When I posted the first response I had only seen about half of the
total replies that were actually posted. The op's statement that
the problem follows the tube shows two things, the tube is gassey
and the grid circuit resistance is probably to high. Some of my
old books show 47k as the maximum recommended control grid
resistance. Low d.c. grid circuit resistance helps stabilize
the runaway tendancy in power output tube circuits.

Thread Tools	Search this Thread
Show Printable Version	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
McKay Dymek DA100E unusual failure mode	Ron Hardin	Shortwave	1	December 19th 05 12:42 AM
We Need a BANDWIDTH-BASED Frequency Plan - NOT Mode-Based.	Expeditionradio	Policy	43	February 8th 04 08:47 PM
FS: Old tube sockets, 4, 5, 6, 7 pin, Hammurlund, GR, ceramic, phenolic,matching plugs, extenders	Al Schapira	Boatanchors	0	January 19th 04 10:54 PM
CCIR Coefficients METHOD 6 REC533 // AUCKLAND --> SEATTLE	http://CBC.am/	Shortwave	0	July 16th 03 08:21 AM

Menu

About Us