PRO-2026 Can I silence the keypress beeps?
 

Is there a way to eliminate the beeping that is accompanied with every
button press on the scanner?

yes

In article ,
says...
yes

Kids :/
--
-----------
Dwayne
http://groups.yahoo.com/group/BC895/

you asked

In article ,
says...
you asked

Hey there smartass, I didnt ask anything.
--
-----------
Dwayne
http://groups.yahoo.com/group/BC895/

better than a dumb ass

WELL... WHAT IS THE PROCEDURE ANYWAY? I HAVE A SIMILIER SCANNER THAT DOES
THE SAME! HELP?
"John Maxwell" wrote in message
om...
(JER1538A) wrote in message
...
yes


OK, I should have known better...
The question is: What is the procedure for silencing the beeps when a
button on the PRO02026 is pressed?

Justice Gustine wrote in
:

Have this from the bit vault:




Look in your service manual for J4 which comes off the control(CPU)
board.

Pin 5 on the ribbon cable is clearly marked "BEEP". Remove the
ribbon cable from J4 and bend out the wire that goes to Pin 5.
Bingo, beep gone.

Or better yet,install a switch like I did.
You'll miss that beep at times,like when entering a bunch of freqs.
The beep is a confromation that the key was indeed pressed.