POC32
 

I am wondering exactly how to use this software.

I have the frequencies needed. I have the scanner. (BC760XLT) (Not Tapped)

How do I set this program up properly to decode signals.



---
Outgoing mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.707 / Virus Database: 463 - Release Date: 6/15/2004

Soundcard 'sblaster 16'

You plug in the audio from the scanner to your sound card mic in.
You might need to adjust some settings

Options/load&save check load last list at startup & save automatically
after 30 mins or whatever.

Under Options/Options timsplan: should be set 3 seconds/uncheck TCP/IP
remote access on port

Options/Pocsag/decoder make sure you have skyper mode checked and
everything in this section should be left alone

Next over hardware&CO
Check monitor signals/Enable soundcard/Channel should left alone (1)
Error correction should be check off


Hope that answers your question
--
John Medica
System & Network administrator
Listening-Post
Toronto Ontario, Canada

NAMA, Listening-Post, Ontario Unlisted Frequency Guide

K, got everything else, but not understanding this last sentence.

"news.vif.com" wrote in message
...
Soundcard 'sblaster 16'

You plug in the audio from the scanner to your sound card mic in.
You might need to adjust some settings

Options/load&save check load last list at startup & save automatically
after 30 mins or whatever.





---
Outgoing mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.707 / Virus Database: 463 - Release Date: 6/15/2004

ScannerMan wrote:

Under options/properties/list management (under load & save) check mark
both load last list at setup & save automatically after xx minutes


You might need to play with the audio level on your scanner.

--
John Medica
System & Network administrator
Listening-Post
Toronto Ontario, Canada

NAMA, Listening-Post, Ontario Unlisted Frequency Guide