Balun for "F"type Connectors??????
 

You can find any connector needed @ Universal Radio . . .

wrote in message
ups.com...
I have a reciever that has 2 screw antenna connections, 300 ohm. I
currently use RG-6 coax so I use a 4:1 matching tranformer at my
reciever and also at the Windom antenna in the attic.

I would like to setup a 90 ft random wire antenna outside using the
RG-6 and feed thru a ground block to the matching transformer into my
reciever. I'll need a 9:1 balun at the feed, but have not found a
ready made balun that accepts the "F" type coax connector. The ICE-180
and one currrently on eBay use a SO-239 connector and I have not found
connectors available to adapt to the RG-6.

Does any one know of a 9:1 Balun that accepts the "f" type connector?

Brian

Balun for "F"type Connectors??????
 

OK - checked site and may have a combo that works... I don't see an adapter
but the combo of pieces might do it. A balun with a "F" type connector would
be better but...

Would the following sound right?

I would come off the Balun that has a SO-239 connector with a (PL-259 to
PL-259) length of coax. It has a PL-259 to mate to the SO-239 on the balun,
(I think that is the male connector for the SO-239). I would then run it to
a SO239 to F male adapter. Use a F coupler to my RG-6 coax connector and
then through a ground block to a 4:1 matching transformer into my receiver.

Sound Right?

Brian

"Lisa Simpson" wrote in message
...
You can find any connector needed @ Universal Radio . . .

wrote in message
ups.com...
I have a reciever that has 2 screw antenna connections, 300 ohm. I
currently use RG-6 coax so I use a 4:1 matching tranformer at my
reciever and also at the Windom antenna in the attic.

I would like to setup a 90 ft random wire antenna outside using the
RG-6 and feed thru a ground block to the matching transformer into my
reciever. I'll need a 9:1 balun at the feed, but have not found a
ready made balun that accepts the "F" type coax connector. The ICE-180
and one currrently on eBay use a SO-239 connector and I have not found
connectors available to adapt to the RG-6.

Does any one know of a 9:1 Balun that accepts the "f" type connector?

Brian






--
Posted via a free Usenet account from http://www.teranews.com