Hello,a friend of mine gave me a hw32,unused since 15 years in a
radio club that had stopped its existence ,it was in very bad
condition,with many bad contacts,a total misalignment,and several
burned tubes,I soldered again everything,I replaced tubes,cleaned all
that I could,and after two days of hard work (!!!about 10 hours each
day),all tubes are on,the receiver works well,it is well in the
specified band,with good sensitivity,alignment works well and is
precisely done.But the transmitter gives nothing,the tubes seem
correct ,I substituted them with a hw22 I also have.In you opinion
where should I look?? Voltages around pa are here and correct.
I think I have done most of the way ,but ideas would be welcome.I have
the manual. Thanks very much,73 Alain F1GQB