mechanical question, aluminum swaged joints

May 16th 06, 10:23 PM posted to rec.radio.amateur.antenna

Dave

Posts: n/a

mechanical question, aluminum swaged joints

Anyone a guru on swaged aluminum joints?? When swaging 1.5" tubing down to
accept 1.25" tubing what would be an acceptable ID tolerance??

Reply With Quote

Thread Tools	Search this Thread
Show Printable Version	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Universal Aluminum Tower Question	Bob	Antenna	4	December 9th 05 02:33 AM
Making aluminum tubes telescope smoothly, with good electrical conductivity?	[email protected]	Antenna	3	May 8th 05 12:11 PM
Good morning or good evening depending upon your location. I want to ask you the most important question of your life. Your joy or sorrow for all eternity depends upon your answer. The question is: Are you saved? It is not a question of how good	[email protected]	Antenna	0	April 25th 05 04:43 AM
Question Pool vs Book Larnin'	Mike Coslo	Policy	24	July 22nd 04 06:50 AM

All times are GMT +1. The time now is 07:10 PM.

About Us