Reply
 
LinkBack Thread Tools Search this Thread Display Modes
  #1   Report Post  
Old February 10th 04, 07:01 AM
Ronny Julian
 
Posts: n/a
Default FS/FT: 48vdc in/110vac 4kva inverter REPEATER OWNERS LOOK!!!

I can ship this but at 160 lbs buyer should consider pickup in Marietta, GA
This was taken out of service in excellent working condition but since it is
not new and there is one to be had. No warranty of any kind is given.
Asking $500.00 or trade for solid state HF Xcvr/general coverage I prefer
ICOM or Kenwood.
Abacus Controls 443-4-48M3 single phase inverter.
Input Voltage: 48VDC.
Input Voltage Range: +/-20% typical.
Output Voltage: Single Phase-115V for 60Hz
Voltage Regulation: 2% or less for combined no load to full load changes and
rated input voltage changes.
Fixed frequency oscillator, crystal controlled with a stability of +/-0.05%.
Output Power: 4000 Watts
Output Waveshape: Sinewave less than 2% THD, 1%max, any single frequency.
Less than 4% for non-linear loads such as computer power supplies.
Load Power Factor: 0.7 lead to 0.7 lag. Continuous zero lead to zero lag at
full rated output without damage.
Peak Output Current: 110%, subcyclic reset.
Duty Cycle: Continuous at full rated output.
Efficiency: Between 60 to 90 percent depending upon DC input voltage.
Typically 70% from 40% of full load to full load.
Output Configuration: Input to output is transformer isolated and floating.
Either side may be grounded.
Phase Angle Accuracy: Digitally controlled to within +/-2 degrees for
balanced loads, for fixed or adjustable outputs.
Protective Circuits: All models are equipped with automatic overload
protection, including short circuit. Automatic reset upon overload removal.
Circuit breaker or fuse on the input and fuse on the output. Automatic
shutdown for input over-voltage, undervoltage.
Extended Operating Temperature Range, -25°C to +55°C.
Non operating -20° to +85°C.
Ambient Humidity Range: Less than or equal to 95% to 25&dge;C, less than or
equal to 75% to 40°C and less than or equal to 45% to 50°C.
Input and Output Terminations: Rear mounted barrier strips provided. High
current DC inputs have brass studs or bus bar.
Construction: standard 19" rack mount.

If you require this type of inverter, it's a bargain at my price.

Contact me off list. I'll have this with me at the Dalton GA Hamfest.



Reply
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
HELP: 2 Meter Repearter intermod from 2 Pager transmitters near repeater site Photoman Equipment 12 December 22nd 04 06:17 PM
HELP: 2 Meter Repearter intermod from 2 Pager transmitters near repeater site Photoman Equipment 0 December 21st 04 01:48 AM
CW Testing Question Mike Coslo Policy 52 May 29th 04 09:24 AM
FS/FT: MOTOROLA MSR2000 VHF REPEATER R. Belcher Equipment 0 December 12th 03 03:21 PM
FS/FT: MOTOROLA MSR2000 VHF REPEATER R. Belcher Swap 0 December 12th 03 03:21 PM


All times are GMT +1. The time now is 10:07 AM.

Powered by vBulletin® Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004-2025 RadioBanter.
The comments are property of their posters.
 

About Us

"It's about Radio"

 

Copyright © 2017