FL-7000 Info Needed...
 

Well , I think I just got burn't , bought an FL-7000 MINT of a guy in
California , When I hook it to my Kenwood TS-870SAT along with the ALC
cable and key up , the TX led comes on and then instantly the OPERATE
LED flickers green then off. No power output but the TX light comes on.
Does this amp requires a voltage at the ALC that my Kenwood may not be
generating? The book says ALC 0 to -9 VDC , I measured the Kenwood and
it stays around "0" +/- a few millivolts. Did I get screwed or am I
doing something wrong? N4ATS