View Single Post
  #4   Report Post  
Old August 27th 03, 03:11 PM
OZARK333
 
Posts: n/a
Default

EVERYONE THAT COMES BACK TO ME SAYS IT HAS A BUZZ
Easiest mistake is power wires being
too small. If you have a 12 volt battery
laying around, connect it to the amp
and leave the vehicle connection on there
too. Be sure to check the polarity, this
is no time to get it backwards!
Try the amp again. If the buzz is gone
you have inadequate voltage/amperage.
This is most likely due to power wires
being too small. Palomar 225, i figure,
will need 25 amps max so 12 gauge min.,
10 gauge would be best, would
probably do the trick. Wire direct to the
battery. Do not go to a fuse block. If you
wish to fuse it do so at the battery. I also
am assuming you have a low SWR.
Good luck....333


"Got RF?"