"sideband" wrote in message
om...
Somewhere.. I'll have to dig through my old stuff and scan them in..
it's been nearly 15 years since I did that.. If I run across 'em, I'll
be sure to get it done.

I'd like to see the little ******* as well.

Heh, "Nader's Nightmare". I love it. ;-)

Jeff



-SSB

Steveo wrote:
sideband wrote:

Here's the steps, in order:

Take 65 corvair. Remove engine. Cap Diff. Put new clutch and plate on
front of tranny. Remove back seats. Cut hole in floorpan. Install
rollcage and crossmember. Lovingly slide LT1 into place where back
seats used to be. Bolt to tranny and motor mounts. Hookup wiring.
Install radiator under "hood" and run piping. Replace all fluids.
Testfire motor. Install 50's series tires on rear axle. Install 60's
series tires on front axle. Install trunk where old engine compartment
used to be. Paint corvair metallic burgundy. Stencil "Nader's
Nightmare" on both rear quarterfenders in bright fire engine yellow.
Watch Steveo's countenance drop when he realizes his Hemi is no match.

::SMIRK::


KEWL! Got pics?