Steveo wrote:
Steveo wrote:

jim wrote:

Steveo wrote:

jim wrote:


Steveo wrote:


jim wrote:



Steveo wrote:



Sorry for the OT question, but I couldn't find a small engine
group.

I just pulled the flywheel on my Briggs 18hp v-twin Z-cart.
(starter repair)

Should I clean the armature/magneto contacts with anything besides
air while I have it off, or leave it alone?

Thanks.

Steve,
According to my B&S repair manual do not soak the armature in a
cleaning solution. The armature commutator, if it needs cleaning,
can be cleaned with 000 sand paper. Don't use emery cloth as it
will embed in the commutator and cause rapid wear. HTH, Jim.


Thanks Jim, what do you think about a non-residual, plastic safe
contact cleaner?

if you were going that route then alcohol could work but the manual
specifically mentioned no solutions were to be used. are you sure it
needs cleaning? is anything pitted or burnt/glazed?


I just pulled it this evening after work, so I've not even blown
it off with air and looked close at it yet. I was going to do that,
but my wife came back to the barn and told me we had nasty weather
on the way. (strange weather day here)

It may not need anything more than a soft air cleaning, but I figured
it wouldn't hurt to ask.

yeah those armature contacts can be very sensitive. can send a paper
copy of the manual if wanted. covers a lot.
50+ mph winds expected for tomm on the island. going to get what you
are getting...
alrighty back on topic, use a 575m6 mic on the 2510 as the stock one is
just fair sounding.

Should I hook it up to Jay in the Mojave's super antenna, or Dave and Deb's
108" first? I have both. (nostalgic ng value ya know)

try jays first. as a base, the mounting bracket isn't needed (or had).
nostalgic value eh?