On Fri, 26 Mar 2004 17:45:28 GMT, "Harold E. Johnson"
wrote:
I've never replaced one, but the thread count is the same as some bulkhead
BNC's that I have, and would expect them to be replaceable if you took care
to NOT do at least one of the above. Look at the replacement connector and
ascertain that it is the same as the one you wish to replace before taking
that giant leap. That particularly pertains to LENGTH of the threaded
portion of the connector as well as the thread count itself. There's not a
lot of spare room on the inside. Just might require some machine shop
turning of available BNC connectors.

It *is* a standard bulkhead/chassis mount. Same threads and depth.
It was a little too tight until I wetted the threads with a little
WD-40. Then it went in easy as could be. Hardest part was removing
what felt like 50 little base screws. This thing is built to
withstand 50 g.

BTW, do you have a spare foot or two to sell? I am sure if I order
from HP it will be 25 cents per, plus $12 s&h.

Ken KC2JDY

Ken
(to reply via email
remove "zz" from address)