Don't buy Rat Shack junk!
Dave!
On Tue, 30 Mar 2004 01:07:55 GMT, "Rob" wrote:
I installed a CB in my Jeep Rubicon for use when my buddies and I go trail
riding. I mounted a *ahem* 48" Radio Shack fiberglass whip on a right angle
antenna mount directly to the rear bumper. I ran a 20' Radio Shack 50 ohm
cable from the antenna to the transmitter mounted under the seat (Cobra 75
WX ST).
Power is supplied by a 4 ga. wire directly from the battery. I scraped off
paint under one of the seat mounting brackets and bolted the wire to that to
get a good ground.
The problem I'm having is calibrating the SWR meter. When key and hold down
the mic, I turn the meter's calibration knob all the way to the right and
the needle is still short of the calibration mark.
Any suggestions would be greatly appreciated.
Rob Kulp
-----= Posted via Newsfeeds.Com, Uncensored Usenet News =-----
http://www.newsfeeds.com - The #1 Newsgroup Service in the World!
-----== Over 100,000 Newsgroups - 19 Different Servers! =-----