The power reading on a deadkey is OK. It's just low on the peak reading
during modulation. Would the diodes do that or could it be a capacitor?

Chris
"N4ATS" wrote in message
...
| Typical Problem , There are 4 germanium diodes in between the input and
| output connectors on a small board. 2 of them are voltage dividers and 2
| of them are for forward / reflected power . Most likely "1" of those
| germanium diodes is open , this would give you exact 1/2 reading.
|
| Chris wrote:
|
| I have a Dosy PM-1000-TS meter that isn't reading peak or PEP anywhere
near
| correct. It reads less than half of what it should. Does anyone have or
know
| where I can find a schematic for it? Any ideas what might be bad?
|
| Thanks,
| Chris
|
|
|