On Fri, 31 Dec 2004 00:40:51 GMT, Lancer wrote:
U Know Who wrote:
"Lancer" wrote in message
ews.com...
On Wed, 29 Dec 2004 16:17:01 -0800, Frank Gilliland
wrote:
On Wed, 29 Dec 2004 17:55:16 -0600, itoldyouiamnotiamnotgeorge
wrote in
:
Frank Gilliland wrote in
om:
Current equalizing resistors is another way to do it. It's common
practice in SS audio amps to use emitter resistors to equalize the
currents between parallel transistors. But I would hesitate using them
with modern alternators because I don't know how it would screw with
the regulators -- some have a local sense line and others have a
remote sense line -- a resistor in the load might send the regulator
into seizures.
Frank it is very easy a single regulator will control the field voltage
on
both alternators. This way they would run the same and share the "Load"
I thought about that, but wouldn't the rotors need to be locked in
phase?
Phase? The control voltage is DC, the outputs are DC, am I missing
something? I know that the output of an alternator isn't "pure' DC,
but it will never be 180 degrees out.
Alternators deliver 3 phase, approximately 120 volts output at working
RPM.
Yes I know that, The output (at least on most automotive applications is
DC.)
I have seen modifed alternators with 3 transformers on them to provide
higher voltages for B+ for transmitters.
BTW Randy, I wasn't trying to be a smart ass with my answer.
|