I completely agree..................I have a multitude of vias on all of my
boards, especially around the RF components. When a system has 80dB gain at
one frequency, it is just to easy to have things fly, otherwise.
On another note, I have completed the first pass of my quasi-synchronous
detector. Audio is very crisp, and since no PLL is involved, there is no
lock to lose. Basically, it consists of splitting the I.F. signal into to
paths...........one path feeds the input port of a Gilbert Cell mixer, while
the other path feeds the input of a high gain limiter. The clipped output of
the limiter feeds the LO port of the mixer, and the audio is taken from the
I.F. port of that same mixer.
It is interesting, when I compare it to the envelope detector output of the
receiver. While the envelope detector output exhibits distortion from the
selective fading mechanism, the quasi-sync detector output remains very
clean, all the way down to the .1uV lower system limit.
My next iteration will use a Philips SA637.................if this circuit
work out the way I expect it to, I will have a single chip solution for this
function. I just need to check the parameters of the LO input, low frequency
limit of the mixer, etc.
Pete
Telamon wrote in message
...
In article , starman
wrote:
Pete KE9OA wrote:
I usually go for less than one tenth of a wavelength for maximum
spacing
between vias. I never lay out the vias on a grid. This is one of the
things
I learned at one of the EMI/EMC classes I took at when I was working
at
Rockwell-Collins. I understand that different folks have different
approaches to board design, and these different approaches do work
well, my
approach has been ok, with boards I have been designing well up to
5GHz. I
do need to state that I am not the foremost expert in this field; I am
just
a simple soul that is scratching the surface of the RF realm!
Given that the highest HF frequency is 30-Mhz, then 1/10 wavelength
would be about 1-meter. This is much larger than the circuit boards in a
radio like the R8, so how important would it be to adhere to the 1/10
wavelength rule for grounding an HF board?
We were discussing what had to be done to prevent board features from
becoming resonant structures on the board and yes at 3 to 30 MHz it's
much less likely due to propagational effects alone but still possible.
If a trace on the board is not closely associated with a ground plane
then its impedance is high and can look more like a lumped inductor than
a transmission line. If the following input to the next device or
circuit has enough capacitance it could resonate anywhere in the HF
spectrum. There are other reasons for via spacing like tying ground
planes together so they look unified electrically. One goal dictating
via density in board design is to make the RF return current path for a
device on the board as small as possible.
--
Telamon
Ventura, California
|