On 7 Apr 2004 05:22:22 -0700, (davehs67) wrote:

Hi Al-

I was wondering what you used to connect your RX-340 & SE-3 with?
What I'm inquiring here is do you use any type of special BNC cable
(Audioquest, Monster, Rat Shack, etc...). Also, do you by chance know
what the impedance rating is of the SE-3 IF input? I believe the
RX340's IF output is 50 ohms, but not 100% sure. Just trying to tweak
the audio a bit through proper cable matching.

Thanks
Dave

Hi, Dave.

I don't use an SE-3 with my 340s.

Other than avoiding the occasional need to diddle the IF gain and/or
programmable AGC in order to deal with SAM-unlock/relock on rapidly
deep-fading strong signals, do you find much benefit from substituting
the SE-3's SAM?


Good listening,
Al
=================================================
Location: 42N39, 71W09 (Near Boston, MA)
HF Antennas: 65ft TFD, 45ft T2FD, 28ft vertical, 65ft doublet
HF Receivers: Ten-Tec RX340, RX320, Harris R2368, Cubic R3030A
Decoders: Code300-32, Universal M-8000, PK-232MBX/DSP
=================================================