MII,

TRY BUILDING AN [EXTERNAL] ANTENNA "GIZMOE" CONNECTOR BOX:
Most Shortwave Radios can benefit from one of these little
External Antenna "GIZMOE" Connector Boxs
http://groups.yahoo.com/group/Shortw...enna/message/7

GIZMOE BOX's Antenna Input Connector Plug or Two Terminals:
[ Metal {Plastic} Utility Box ]
- One for the Antenna Connection.
- The 'other' for the Ground Connection.
+ Solid Heavy Duty Hardware for Grounding Point.

A = Antenna Connection Point
G = Ground Connection Point {& Plug/Terminal}
* = Space {Blank Space Indicated}
R = Radio/Receiver Connection {Plug/Terminal}
NOTE: Diodes 1N914, 1N4148, ETC.
S = Switch Medium Duty Toggle Switch works best.


G**********A = External Antenna
|----o)----| = NE-2 Neon Bulb or Gas Discharge Tube {EMF Pulses}
|**********|
|--|--|--| = Forward Diodes {Minor ESD Discharges}
|**********|
|--|--|--| = Reverse Diodes {Minor ESD Discharges}
|**********|
|--/\/\/\--| = 10K Ohm Resistor / Potentiometer {Static Bleed}
|****^******
|****|******
|****------|
|**********O
|**********S = Switch {Antenna Connection and Dis-Connect}
|**********O
G**********R = Radio's External Antenna Input

GIZMOE BOX's Antenna Output Connector Plug or Terminals to
match-up with the Radio/Receivers. Can use a short piece of
Coax Cable or a set of short wires between the Gizmoe Box and
the Radio/Receiver with the proper Plug/Terminals on the end.

Hope this helps ~ RHF
..
..
= = = m II wrote in message
= = = news:vIVoc.5034$j6.209@edtnps84...
Jim wrote:

Anyone else having problem with Ten Tec Rx-320 blowing front
end FET's? Any mods to prevent this or is there a replacement
FET with less tendency to short out? This is definitely a
design fault, as I have 3 receivers in parallel on same
antenna and the R320 is the only one blowing FETs.

Mine is #08C104XX with no problems in about three years.
What are the chances of static build up in your antenna?

mike

..