Response is flattened through gain controlling the pre-amp from a look-up
table held in the micro's EEPROM. The alignment procedure is automated using
the HB-IP bus from the spectrum analyzer and a computer. The
computer/analyzer also looks for harmonic content and spurious emissions
during this procedure. Think it takes about ten seconds to do this.
"Richard Clark" wrote in message
...
On Fri, 04 Mar 2005 01:13:39 GMT, "Thomas Magma"
wrote:
Wow this is a long thread. Don't really know where I should put my two
bits
in, but here it goes.
I have designed several RF PA sections in the past. 500MHz at about 50W.
Pretty easy stuff if you have the right tools and know how to use them.
The
tools I like using for matching the power output FET is two triple stub
tuners. One on the input of the FET and one on the output. So it
goes...pre-amp (50 ohm output) - stub tuner - FET - stub tuner - 50
ohm
dummy pad - spectrum analyzer. Then just tune the stubs for the
performance
you desire, these include: efficiency (thermal issues), harmonic content,
spurious emissions, load VSWR considerations, cold start, ect. Then
remove
the FET and look into the triple stub tuners with the network analyzer.
Model and duplicate the network out of discrete components that can
handle
the voltage/power, send the design off to the enviro test lab, and head
home
early for the day.
Cheers,
Thomas
Hi Thomas,
Thanx, your two bits were worth more than the academic plug nickel.
This is something that our original poster should hearken to as his
needs were obviously production oriented. Bench experience will trump
cut-and-paste theory in a heart-beat.
However, triple stub is pretty aggressive. How long did it take you
to flatten response?
73's
Richard Clark, KB7QHC
|