is it possible you are misleading people ? you might need to do some
tweaking to get it going, they say they spent 10 months on this.

read the comments on their web site, some people say that ferrite beads are
needed and that the speaker is great

LINK:

http://www.heilsound.com/amateur/cle...ch_speaker.htm






"Ron Hardin" wrote in message
...
THe new Heil Clear Speech arrived; save your money, it's a piece of junk.

Audio levels all wrong (no output power), produces feedback under
circumstances where it should not, apparently unshielded, audio seems
distorted even when bypassed. I would not be surprised if the unit
were defective, but I fear it is not.

Its noise reduction amount is offered in steps; these seem okay
(factoring out the distortion) though all steps are less noise
reduction than the Am-com Inc units offered as its single step.

``Bypass'' doesn't bypass the unit; and you lose the bass response,
and no audio through if the unit isn't powered. It shares this fault
with the original Am-com unit, though the Am-comII remedied it by
changing the function of its single switch to actually bypass the unit
when it powered it off. (Cost was that the unit started cold when
you switched it in.)

Physically, I can't figure out how you're supposed to mount the thing;
they have one idea in mind but I don't know what it is.

So anyway, it's a large odd shaped piece of plastic that doesn't work.
If you liked the Am-com version of Clear Speech, you'll hate this.

Maybe somebody else will pick up the Clear Speech algorithm and do it
right. It's great for noise reduction; I have three of the Am-com
base units around the house, and had high hopes here.

--
Ron Hardin


On the internet, nobody knows you're a jerk.