"- - Bill - -" exray@coquidotnet wrote in message
...
Tim Wescott wrote:
I wish it were, but its in the input circuit -- when the dial (in band
'C')
reads 3MHz the coil tunes at 4.5MHz, as verified both with a grid-dip
oscillator and with a signal generator/scope. At the low end of the
range
it's not so bad.
I just looked at the schematic...I gather that there is a "T1" for each
band although only one is shown?
Is it just that one band or do all of them misbehave?
-Bill
Yes, that's the arrangement -- I've checked the two lower bands ("D" and
"C") and they both have the problem. The other two don't, which is odd --
you'd expect the problems to be worse at the high-frequency end.
|