I wish it was something so simple! My Alpha doesn't have a problem
with the same cables, load, nor does the SB-220 on 40M.

Thanks, though - sometimes it's easy to overlook the obvious.
LJ



Gary Schafer wrote in message . ..
Sounds like you have a bad load or a bad cable connection between the
watt meter and the load.

73
Gary K4FMX


On 10 Dec 2003 10:37:25 -0800, (LJ) wrote:

I recently picked up a used Heathkit SB-200 Linear Amplifier. I tried
it out last night for the first time - on 20-Meters. Power out was a
little more than 700 watts, worked fine.

I then tried it on 10-Meters, and looking at the Drake W-4 Wattmeter
on the 2000W output scale, it was pegged! Looking at the reverse
scale, it was pegged on the 200W reflected scale. This tells me that
the amp was probably going into oscillation.

I wasn't too surprised to see this, as I have an SB-220 that just
spits and arcs continuously - it's unusable on 10-Meters (other bands
are okay). I haven't had a chance to install the Harbrach suppressor
kit yet, which I hope will fix that problem (it puts out over 1300W
output on 20 Meters, no problem, so the amp does work.)

I decided to then try 40-Meters on the SB-200, figuring that if
20-Meters worked OK, 40 should be okay, too. Wrong - the same thing
happened - nice 50 ohm load, keying the amp while driving with 60-100
watts, the wattmeter is pegged again - forward and reflected.

I can see why 10-Meters would have a problem, but with 20-Meters
working fine, I'm surprised that 40 would have a problem. I haven't
tried it on 80 and 15 Meters yet, I'll try that tonight.

Any suggestions?

Thanks & 73,

Larry K7LJ
(please email direct, off the list)