"Marshall Goldblatt" wrote in message
...
Hello all,

I have a Tailtwister (TX-2) rotor mounted on a Rohn 25 foldover tower.
While the tower itself appears to have survived intact, hurricane
Katrina snapped the mast and destroyed the antennas. I need to fold the
tower over to work in it, and likely leave it folded over for a fairly
extended period. This will leave the top of the tower and the rotor
upside down. Unfortunately, it is still the rainy season here, and the
last time I needed to do this, rain water got into the rotor and settled
in the bell, causing rust and other corrosion damage inside the rotor,
because it is only weather protected when it is upright. I would like
to seal the rotor to prevent this from happening again, but none of the
ideas I've had so far (wrapping it in plastic garbage bags, using duct
tape, using sealing foam) are usable, either because they don't seal
well enough to keep water out or because stuff may get up inside the
rotor where I can't get it out.

So, does anyone have any suggestions?

73, Marshall - W4EMB



Maybe ... get some axle grease, or RTV sealant would be better, perhaps.
Both should peal off reasonable well.

One other thing I am concerned with tho. I always heard that the rotar
must be kept in a vertical position or the grease would drain out of the
bearings? Wives tale ??? I don't know. But I always keep mine vertical
when stored.

Dan/W4NTI