"Jon L" wrote in message
oups.com...
Hey Jack! When checking the coax with the ohm meter as you described,
what sort of a reading shoud you get, and I suppose you should set it
to DC, but at what voltage? I know these are basic questions, but I am
sure I am not the only one who is unsure. Thanks for the reply in
advance! Have a great week! Jon.

Set the meter on ohms. You should get infinity between the center conductor
and ground. You should get a reading very close to zero when checking ground
to ground or center to center.
On your previous post on swr meter use, place in line close to radio. Place
switch to for, key mic and adjust to where it says cal, the switch it to
ref. That will give you your swr reading.