I received an old HRO from some jerk in VE land (nothing against VE's) that
packed my receiver inside a flimsy cardboard toilet paper carton with empty,
capped juice bottles between the rig and the box (Welch's Grape I believe).
They had mold inside from the residual juice which had remained when
emptied. Let me tell you - that box stunk terribly. Some of the caps were
loose and the bottles were not air tight. Naturally, the main tuning knob
had been bashed into the front panel when all the juice bottles had shifted
during shipment. It was a mess. If I could have gotten my hands on that
fellow it would not have been nice.
Roger, KL7Q
Bill Powell wrote in message
...
To-date, I have found VERY FEW (eBay) people who have the FOGGIEST
idea of how to properly pack a boatanchor. Especially the "trust me -
I'm an eBay professional" types.
So... I've been insisting on (and paying for) double boxing and heavy
cardboard boxes.
However. . . The "Joe Average" average double-box job can (usually)
lead to a crunched front panel - or worse.
A Knight transmitter I recently received was double-boxed with the
inner cushioned from the outer with a 1.5" layer of peanuts. However,
the front-panel of the transmitter had been stood off the side of the
inner box with a thick sheet of solid, hard styrofoam.
Right now I'm assuming that the "locked" shafts are simply due to the
knobs being scrunched just a little bit tighter against the front
panel than they should be.
I hope.
OTOH, a Johnson Viking Valiant (just add chain - no concrete required)
I received was so well packed that despite being dropped, the only
things amiss were a "floating" audio interstage under the chassis and
severely bent mountings on the mod transformer: absolutely NO front
panel damage or tube breakage!
My quest for knowledge:
Has anyone here tried DIY foam-in-place?
I'm talking about embalming the hunk-o-iron in double heavy duty
trashbags, shooting "some" (think of a kid with a can of whipped
cream) of the DIY spray-in foam insulation into the 4 corners of the
inner box and then setting the bagged anchor into the mess till it
sets. A follow-up would (hopefully) lock the bagged goodie
more-or-less into the middle of the box.
Or am I just gonna make a nasty mess?
TIA,
Bill - WB1GOT
Oh - getting the thing back out is someone elses problem. :-)
|