Would a 12 V deep cycle- Optima work in a APC-UPS 1400R I keep my servers
and dyno on with it along with some routers and switches. I don't know the
output, the battery fails and I now have it frightfully bypassed. The
batteries died and are almost 2 bills to replace. voltages ? issues? but
I have a few Optima batteries from wrecked race cars that would be
perfect!
===================
Suggest you check the charging instructions on the original battery and
compare these with the ones applicable to the Optima type of battery.
The battery in a UPS is on 'standby duty' The charging instruction for a
YUASA SLA found in many UPSes has the following for standby duty :
Voltage regulation : 13.5 - 13.8 V
Initial current : Unlimited

Connect the Optima battery to the UPS and check the voltage when the
battery is fully charged . You can charge the battery externally to say 13.5
volt before you connect it to the UPS. If the fully charged voltage is in
the above range ,you can safely use it for this purpose.
I would think that any 12 V SLA will happily work with your APC UPS 1400R
,provided its capacity is adequate for the load to be maintained for the
minimum time needed. If you use a number of batts in parallel ,please
ensure there is an adequate FUSE in each battery circuit !
You can also connect a much larger 12 V sealed battery to the UPS (for
example those used in electric golf trolleys). Even non-sealed batts can be
used provided they are located in a well ventilated area .
I have non-sealed batts located on the loft connected via leads made from
welding cable running to equipment in the ground floor radio shack ( to feed
radio equipment requiring a peak current not exceeding 25 Amperes)

Above I mentioned batts for Golf trolleys because their cost is very
reasonable nowadays there being a relatively large demand , hence
competition (pun intended)

Frank GMØCSZ / KN6WH