Mike,

Heath used spade bolts in many of their tube rigs. I may
have some in my parts bin. Let me look and let you know.
If I have some, I'll send 'em to you for nothing.

73,
Dean K5DH

In article .com,
says...

Hello all,
I hope someone can help me on this one. So the story goes....last
night I pulled a rusty tuning cap sub chassis from a Halli S19R.
Cleanup up really nice. When I went to remount the tuning cap, snap go
the threaded shafts that go from the bottom of the cap to the sub
chassis. Brittle doesn't even describe them. I was being careful. The
feeling I had was close to the feeling one gets when cleaning an old
glass dial and wiping away the markings. I went online and found out
that the name of those screw goodies is a spade bolt and a co. that
sells them has a min order of $40 for 100. (I need 3). They consist of
a 6-32 threaded shaft about 1/2 in long and a flat top that spreads out
alittle (where the flat goes lengthwise to the screw thread) with a
hole in it to rivet to the var. cap. By any stretch of the imagination
does anyone have any of these gems that I can purchase from you or know
a source to refer me to? Thanks in advance, Mike KF6KXG