RF amplifier for CB frequency - Suggestions needed
Seeker wrote:
Hi, I'm not a ham-radio guy, but I know you all know your stuff and might be
able to help me out.
Presently I have a transmitter (in a truck) and receiver (Water pump system)
set up I use to irrigate a motocross track. The signal is transmitted
1/2mile, parallel to high voltage lines. Frequency is at 27.145MHz and at 1
Watt. Unfortunately the signal reception is intermittant - I'm assuming
because of the EMF of the high voltage lines. I have both a really good
antenna for the reciever and transmitter.
I need a CB amplifier for the transmitter. Perhaps 3 Watts? Preferable w/ a
BNC connector and runs off 12Volts. Does anyone know where I can get such a
device?
if your cb isn't putting out even 3 watt it is defective
spend 49 buck on a new cb
your operation will be legal and likely cheaper than any amp you could
build
Thanks,
Seeker
|