Scaling of Yagi design
David wrote:
That's what I expected from people who have practical experience and
understand the principles (much better than I current do).
I managed to track down thinner aluminum rod that is much closer to
scaled values of elements in the original design.
The values should be 3.78mm and I can get 3.175mm
For the 4.73mm , I can get 4.763mm.
This should now be close enough to only require small trim in length
to compensate for small change in diameter.
The diameter ratio would be fine given the first diameter you listed.
The others would be fine also. Just specify what you want to use.
tom
K0TAR
|