jimbo wrote:
I am getting close to pulling some cable through a 1 1/4 inch PVC
conduit that runs about 20 feet from the third floor attic to the
basement. The contractor claims the conduit is a "straight shot" with no
bends. I have three LMR240 cables with PL259 connectors on each end. And
I would also like to pull a 450 ohm length of ladder line. (Measures
about 1 inch.) And I would like to pull at least two 16 gage insulated
control wires.

Any advice would be appreciated.

Thanks, jimbo


Thanks for the great advice. I will leave the ladder line for another
day, another route from attic to basement.

Thanks, jimbo