ANTENNA DESCRIPTION: I recently installed a horizontal loop antenna
for 75 meters. The antenna wire is #12 multi-stranded tinned copper
with 600 volt TEW insulation. The antenna is fed within one foot of
the NW corner, via 25 ft. of 450 ohm twin lead to a 1:1 balun then via
air dielectric RG/8 (21.1 ft.) then to a AT-1500CV. The formula 1005/f
was used to figure the length and to cut the wire. However, due to
the low height about ground (24-26 ft.); the ground capacitance
changed the antenna resonance considerably. The target f (frequency)
was 3.9 MHz with 257.7 ft. of wire. After installation in a rectangle
configuration at 25+/- feet, the resonate frequency was 3.452 MHz.
With a tuner matching the antenna to the "rf" generator (transceiver),
the NVIS signal met the 100-200 mile range that was estimated.
The antenna was tuned - cut (shortened) to increase the
resonate frequency into the 75 meter phone band. After some
estimating of desired length at the low elevation and cutting and
pruning a resonate frequency of 3.790 MHz was obtained, that has a
VSWR of 1.6 to 1. The resonance was found with an MFJ-269 without the
tuner, 1.6:1 @ 3790 KHz. The tuner matches the load to 50 ohms for the
PW-1. The area of the loop decreased and the perimeter length is 229.5
linear feet. Again with the use of a tuner throughout the phone band
produced a NVIS signal range that was very good. K4WYS

On Sun, 14 May 2006 16:34:44 -0400, Sonny Hood wrote:
I have an antenna that needs 100 ohm twin lead to match the impedance
of the feed point. The 450 ohm lead has messed up the match and
screwed up the resonance, does anone know of such an animal?
K4WYS