In article ,
"Dennis" wrote:

any of you fellas got any info the LDG range or tuners ?? or used em?

Rgds



Interesting comments on the 706 noise blanker.

I already have a LDG tuner also and that's one of the reasons I would
like to give the 706 a go. Interested in hearing any comment too about
using the 706 and LDG tuner.
73
Dale, K9VUJ







"Dennis" wrote in message
...
In VK, the Holden Commodore is powered by a Buick 3.6 ltr V 6.. the
computer
and electrics in 2000 yr on model Holdens will not allow use a 146.800
Repeater out put on the 2mtr section using a 706MK 2G.. amazing, thats how
i
ended up with this new G, i installed it in a '94 Commodore same motor
earlier PC and Electrics, works ok, but the Internal HASH noise of the 706
doesn't help the cause , but the GAP HEAT IT spkr does,
Injector Primer Pumps cause some bother also, I run a Hi Sierra S/DRIVER
mounted on the Trailer hitch away from the PC , antenna is grounded at the
base hitch plus to Exhaust pipe and again at the engine end i have bonded
the donk to the chasis , and I take the DC off the starter and run it to
to
Netural Links in the boot via 400amp Cable
then each rig (remoted in boot) have their own ferrite DC filters, a lot
more work getting HF mobile in these new rigs


Rgds
dennis vk4sx

"Dan, danl, danny boy, Redbeard, actually Greybeard now"

wrote in message ...
On Sat, 01 Nov 2003 03:34:02 -0800, sent into
the ether:

In article ,
Alan Beagley wrote:

The NB in my IC-796MKIIG seems to do OK. Perhaps others are better,
but
mine definitely does reduce noise -- ignition and other.

-=-
Alan AB2OS


On 11/01/03 12:49 am put fingers to keyboard
and launched the following message into cyberspace:

Icom doesn't seem to make noise blankers. The "NB" button on my
756Pro seems
to stand for "No-purpose Button"


Alan, IC796 must have been a typo, hit the nine key instead of the
zero,
I do that sometimes too. Your's is the only one that seems to be
working

I take it then the noise blanker is not too good in most of the 706
series.

I wonder how the FT-857 is?

My FT-900 is quite good, but I don't think I can get it in my new
vehicle.

Thanks
Dale, K9VUJ


Dale,
The noise blanker on my 706IIG works well on the ignition noise from
my Cherokee sport. I run the power lead directly to the battery,
while keeping it as far away as possible from any other wiring.

It will soon be in a Chevy 1500 pickup. I would think it will do
well there too.
Dan, N9JBF
Amateur radio - What a hobby!
Remove left x for direct reply




--