Chuck,
Already tried to repair it. The break is in the coil, not
at the terminals, or exposed wires. The coil is encapulated
in a ceramic goop I've never seen before. Removing it
will destroy the windings. As a result it'll be hard to count the
windings (its a center tapped coil with unknown tap)even
if I have to rewind it.

Also tried the high voltage arc technique where you use
a HV supply with a big (12K ohm, 10 watt) resistor
in series hoping to weld the break to another adjacent
winding. This worked briefly...

Groan.

Steve
"Chuck Harris" wrote in message
...
Steve wrote:
Just discovered that one of the IF cans in my SX-117 has an
open winding. I know that many Halli receivers used the
50.KHz IF, and probably the same coil. The part number
is 050-200735 which is printed on the top of the can.
Thanks!

Steve
Why don't you fix it? It's big, and the failure is almost always
right where the wire is soldered to the terminal.

-Chuck