On Tue, 21 Oct 2003 21:14:06 -0400, "Tarmo Tammaru"
wrote:


"Roger Halstead" wrote in message
.. .
On Sat, 18 Oct 2003 20:39:15 GMT, yea right wrote:
You might need to use some wire pulling soap (the gooey yellow stuff)
to push the LMR-400 through, but the stuff is stiff enough I would
expect it to go through fine.

It t takes a good can to two cans to get a cable through my 4 inch
conduit now that it has so many cables in it. The yellow stuff is
easy to clean up

Roger Halstead (K8RI EN73 & ARRL Life Member)
www.rogerhalstead.com
N833R World's oldest Debonair? (S# CD-2)

Roger,

If you are going to the trouble of using some kind of conduit, and assuming
it comes in 10 foot lengths, why not just push it through one piece at a
time? That is, push the coax through the pieces of pipe before you join the
pipes together. Besides, LMR400 is pretty stiff.

In my case I have 75 feet horizontal with two 45 bends at each end and
a 3 foot rise at the tower and 86 feet horizontal into the basement.
Getting more into that takes lots of soap and one hefty snake and it
still gets hung up at times.

http://www.rogerhalstead.com/cablebox.htm
There are (I'd have to go count to be sure now), 7 runs of LMR 400, 2
runs of RG-6 for the UHF TV antennas, One does everything cable to the
C/Ku band dish with rotor and polarization, two 3/8ths inch rotor
cable with one used for the rotor and the other for the remote antenna
switch.

With a single run of LMR 400 in 3/4 inch, I think pushing it through
one at a time would work fine. Although for no more than 20 or 30
feet...probably twice that you could easily push one run through the
full length. I'd guess you could push it through far longer runs than
that.

Roger Halstead (K8RI EN73 & ARRL Life Member)
www.rogerhalstead.com
N833R World's oldest Debonair? (S# CD-2)
Tam/WB2TT