Make sure to measure the actual line voltage. While low line voltage would
not cause the HV to read that low, it's always a good idea to know what it
is so you can set the taps correctly.

K8AC

"Levent" wrote in message
om...
Folks,

I just buy a used AL-80A. It is set on 120 V and without connecting
any rig i did connec to gnd and 120. When I turned on I am seeing then
HV is 2400V. AL80A manual is saying that no load must show 3100V. Is
this mean that I need a new 3-500Z or can be something else.

Thanks for the help.
Levent WW2L