Sounds like a manufacturing defect - or they got tweaked somehow ...

Good luck - if you try to bend them to fit, you really should check for
cracks - including all of the bracing and connecting welds.

73,
Carl - wk3c

"Cecil Moore" wrote in message
et...
Carl R. Stevenson wrote:
Rohn 15 is tapered at the top of the sections to fit inside of the bottom
... I don't recall the exact dimensions, but the top, tapered part should
be "concentric" with the bottom of the next section and fit inside.
(you may already know all of this and may be describing something
different)

The two pieces I have are not concentric and each
tapered part slants toward the middle at about 3
degrees rather than pointing straight out. The
slant is enough to cause the pieces not to fit
together.
--
73, Cecil http://www.w5dxp.com