In article . com,
wrote:

Hi,i have a Icom IC-725 that works fine,,but its about 10HZ off
according to the readout
,,,anyone know the pocedure for calibration?

Monte-

I don't know if this will help or not. I found an article in my
archives from last June, that gave an address for the manuals for both
the 725 and the 725A.

http://www.icom.co.jp/manual/externa...ers/IC-725.pdf

http://www.icom.co.jp/manual/externa...rs/IC-725A.pdf

I have not tested the addresses to see if they work.

You will be hard pressed to beat 10 Hz, even if the rig has a TCXO. If
you have the capability of measuring it, all you need to do is find the
adjustment, let the rig warm up a couple of hours, and adjust it. Let
the adjustment stabilize a while and check again. Ceramic trimmer
capacitors seem to drift slightly immediately after adjustment.

Fred
K4DII