On Feb 26, 3:12 am, "J. Mc Laughlin" wrote:
Dear Bhuvan (no call given):

If the antenna is for a LPFM station licensed by the FCC (U.S.A.), then
tight restrictions exist on the height of the antenna. Where are you
located?

In any case, as Richard has said, one may buy an antenna for the purpose for
less money.

73, Mac N8TT
--
J. Mc Laughlin; Michigan U.S.A.
Home: "BK" wrote in message

oups.com...

On Feb 24, 11:19 pm, Richard Clark wrote:
On 24 Feb 2007 04:30:51 -0800, "BK" wrote:

I am still in doubt weather the high gain (nearly 6db not 6dBi) is a
hype.

Hi Bhuvan,

Doubt no longer. You can buy the 6dBi for much less from any number
of other vendors. BEWARE of vendors that give their antennas "names."
Product numbers are sufficient for a commodity market. Better yet,
build your own. All antennas can be scaled to ANY frequency.

The single best advice that you could accept is to raise the antenna
as high as you can.

73's
Richard Clark, KB7QHC

Thanks for your advice to raise the antenna as high as possible. I can
rise a 40 ft of 1 1/2 inch GI pipe on the rooftop of a four story
building to achieve 90ft hight for the antenna that shouldn't cost me
morethan $300 for the transmission of 100 watt at the transmitter
power. I am looking for the high gain antenna as ERP is not mesured
rather transmitter power is the concern here for FM transmission.

Regards,
Bhuvan


................................
If the antenna is for a LPFM station licensed by the FCC (U.S.A.),
then
tight restrictions exist on the height of the antenna.

Where are you located?
................................
I know the LPFM policy of FCC, that stick to ERP. But I am located in
Nepal. Upon inquary to the communication ministry, the engineer there
stated that they would be concerned with PEP. I can feel the
concerened engineer is either having little or excessive knowledge of
FM transmission. What I have seen here is that they would measure the
transmission of a station as 100 Watt at the transmitter power in my
case. So, often stations are built with a stacked array of broadband
antennas. But I can't afford that antenna system though trying to have
a cost effective antenna system to boost the ERP of my station
operating at 100 Watt @ transmitter power.


Regards,
Bhuvan