Many Thanks-I just tried the hold A=B and power up reset and it worked! I
down loaded the Service Manual somebody sent me the link to from mods.dk
site, I found the battery in the parts list but couldn't find its location.
Is it obvious when you crack the case, and is it a common battery to find an
equivalent locally.
thanks again for the tip.
Mike ka1drz
Filter the QRM from my callsign to email


"Clif Holland" wrote in message
...
It sounds like the battery is marginal. Do a reset (A=B plus turn-on) and
see if it corrects the problem. If so the battery is on it's way out.

It's not a PLL problem.

--
Clif Holland, KA5IPF
AVVid
Authorized Kenwood and Icom Service Center
816 W Shady Grove Rd
Irving, TX 75060

www.avvid.com

1-800-214-5779
972-870-0630 (Local)
"Mike" wrote in message
...
I havent used my TS440S/AT in some time and turned it on last night. I
just
keept beeping and the display lit up segments that were not numbers, so
I
quickly turned it off and made sure it was not keyed or anything else
was
amiss externally. I retried t but it did the same thing again. My
suspicion
is that the circuit board battery has finially died? Does this sound
like
the result, and how is it replaced? I went to Kenwoods website to
check
for a service bulletin but there was none, this is probably covered in
the
service manual.
Mike
KA1DRZ
remove the QRMary to email me