Uncle Peter wrote:
"Anthony Fremont" wrote in message


Use less inductance or replace it with a wire link.

I did this and now I'm up to 3580.050; an increase of about 70Hz or
so.. I don't understand how this was designed to work. What is
making the crystal oscillate above its design frequency? I thought
the inductor had something to do with it, obviously not. Is it
being operated in series mode instead of parallel?

I tried putting small cap in series with the adjustable one and that
just greatly narrowed the tuning range and only slightly raised the
frequency. It seemed to be getting unstable at that point as my old
frequency counter started showing variations of quite a few hertz
each update instead of remaining steady. It could be the amplitude
is too low and the counter is missing ticks.


If you want a VXCO, you use the capacitor and inductor to achieve
maximum range of the crystal frequency.

An inductor in series will lower the frequency.

Ok, just like an antenna

A capacitor in series will raise the frequency.

Same thing again, just like an antenna. However, when I increase the series
capacitance, the frequency drops instead of going higher. This I don't
really get.

Eliminate the coil and just use the series trimmer to see how
how high the crystal frequency can be raised before it becomes
unstable or quits oscillating.

Did this, it helps, but when capacitance is below about 10pF, it seems to
get unstable and I still can't achieve the frequency I desire.

As Ian suggested, you can add an inductor ACROSS the
crystal to raise the frequency. Think of the crystal as being
a parallel LC circuit (over simplification) and you'll
be better able to visualize how this works.

Can you suggest a value to start with?

Try a few other color burst xtals in the circuit for the heck
of it. You may not be able to pull the crystal that far.

That's what I'm thinking now, it just won't pull that far high. I can sure
pull it low though. Maybe I should try a 4MHz crystal and pull it down to
3990, this is where the voice transmissions are anyway.