"Don Bowey" wrote in message
...
On 7/4/07 8:42 PM, in article ,
"Ron
Baker, Pluralitas!" wrote:


"Don Bowey" wrote in message
...
On 7/4/07 10:16 AM, in article ,
"Ron Baker, Pluralitas!" wrote:


"Don Bowey" wrote in message
...
On 7/4/07 7:52 AM, in article
,
"Ron
Baker, Pluralitas!" wrote:

snip


cos(a) * cos(b) = 0.5 * (cos[a+b] + cos[a-b])

Basically: multiplying two sine waves is
the same as adding the (half amplitude)
sum and difference frequencies.

No, they aren't the same at all, they only appear to be the same
before
they are examined. The two sidebands will not have the correct phase
relationship.

What do you mean? What is the "correct"
relationship?


One could, temporarily, mistake the added combination for a full
carrier
with independent sidebands, however.




(For sines it is
sin(a) * sin(b) = 0.5 * (cos[a-b]-cos[a+b])
= 0.5 * (sin[a-b+90degrees] - sin[a+b+90degrees])
= 0.5 * (sin[a-b+90degrees] + sin[a+b-90degrees])
)

--
rb





When AM is correctly accomplished (a single voiceband signal is
modulated

The questions I posed were not about AM. The
subject could have been viewed as DSB but that
wasn't the specific intent either.

What was the subject of your question?

Copying from my original post:

Suppose you have a 1 MHz sine wave whose amplitude
is multiplied by a 0.1 MHz sine wave.
What would it look like on an oscilloscope?
What would it look like on a spectrum analyzer?

Then suppose you have a 1.1 MHz sine wave added
to a 0.9 MHz sine wave.
What would that look like on an oscilloscope?
What would that look like on a spectrum analyzer?