On Mon, 09 Jul 2007 10:42:53 -0700, Telspam Electronics
wrote in
.com:

On Jul 9, 12:03 pm, james wrote:
the SSM2166 draws about 10mA of current. Four NiMH AA batteries have
1800mAhr capabilities. At full charge that delivers 5.6VDC to the
chip. Well within the operating range. Should get about 150 hrs of
operation. Add a charging circuit and you have no more issues.

James, you are very similar to Frank... in that you have distinct
ideas. The problem you both have is one of conveyance. I have made
every effort to answer your questions in a civil manner... but you
continue to rant uncontrollably.


9 square feet? 85% stock modulation? "Linearity is not required for
SSB..."? What do you expect, Brian.... a standing ovation?


I'm not sure by what authority you
speak... since you have no design of your own. Therefore, the
conversation with Frank and James is ended as far as I'm concerned.


I have shown you more than enough of my work for you to see my
credentials. If you need more then just ask, I'll email you a copy of
my graduation certificate from USMC Ground Radio Repair Course (MCCES,
29 Palms, CA), my college diploma, and even a copy of my Master's
thesis when it's finished.

You, for obvious reasons, have yet to post the schematic for your amp.


If
some others have questions, I'd be more than happy to attempt to
answer you. If you don't wish to use this forum... I fully understand.
Please email me anytime.


It would be better for them to post their questions in the group so
those of us who know what we are talking about can set them straight
after you attempt to dazzle them with your RF hocus-pocus..... like
trying to sell people an aftermarket compressor when there's already
one built into the radio.... what a scam.

Who was that comedian who did the "instant water" routine? Instant
water... just add water!