On Thu, 9 Aug 2007 08:13:45 -0400, "Jimmie D"
wrote:

I need to measure the loss of aproximately 200ft of coax @ a freq of 1Ghz.
The normal procedure for doing this is to inject a signal at one end and
measure the power out at the other. Using available test eqipment this is a
real pain to do. I propose to disconnect the cable at the top of the tower
terminating it in either a short or open and measure the return loss at the
source end. I have done this and measured 6.75 db and I am assuming that 1/2
of this would be the actual loss of the cable. These numbers do fall within
the established norms for this cable. Can you think of a reason thiis method
would not be valid?


Jimmie

This is way too complicated for me!
My solution would be to build/buy an RF probe and permanently mount it
at the top of the tower. Bring a pair of wires (Coax if you want it to
look really professional) down to the bottom and measure it whenever
or even all the time.

Climb tower once.

John Ferrell W8CCW
"Life is easier if you learn to
plow around the stumps"